HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Administrator&a - Page 236
Replacing a MIC
View all HP NetServer AA 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 236 highlights
Chapter 9 Maintenance Replacing a MIC To replace a MIC, complete the following procedures: • Removing a MIC • Installing a New MIC Removing a MIC Caution: Before proceeding, make sure you are properly grounded using, for instance, a wrist strap with an attached alligator clip that is connected to an appropriate ground. To remove a MIC: Step 1 2 3 4 5 6 Action Notes Obtain a replacement MIC from your service provider. Remove from service the element in which the MIC is installed: Power off the system (the IOP or the CE that you shut down). Remove the fiber cables from the MIC that you are replacing by squeezing the connectors to unclip them and then detaching them. Remove the cover of the system, following the manufacturer's instructions. Remove the screw from the MIC and then remove the MIC. • For an IOP, shut down the IOP as described on page 210. • For CE, shut down the CE as described on page 213. Note the slot in which the MIC was installed. You will install the new MIC into the same slot. 220