HP NetServer AA 4000 HP NetServer AA 6200 Solution Release 3.0 Administrator&a - Page 237
Installing a New MIC, wrist strap with an attached alligator clip that is connected to an appropriate
View all HP NetServer AA 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 237 highlights
Chapter 9 Maintenance Installing a New MIC Caution: Before proceeding, make sure you are properly grounded using, for instance, a wrist strap with an attached alligator clip that is connected to an appropriate ground. To install a new MIC: Step 1 2 3 4 5 6 7 Action Notes Carefully remove the new MIC from its antistatic packaging. Install the new MIC into the correct slot. Replace the cover. Attach the MIC fiber connections by clipping them into the cable receptacles. Power up the system. Record the revision information. Compare the MIC revision information reported during boot to the MIC revision required for your server software (as noted in the Release Notes). If they do not match, run the MTCFLASH Utility, described in Chapter 7, to install the correct MIC firmware; otherwise, the system cannot join the server. Ensure that local and remote connections are cabled correctly. For information about cabling the MICs, refer to Table 2-2 in Chapter 2 of HP NetServer AA Solution Installation Guide. This information is displayed on the screen while the server is booting. Mtcflash - f results in the correct configuration. If all flash components are up to date, MTCFLASH does not reprogram the MIC. 221