Oki MB471 Users Manual Basic - Page 21

Setup The key lights up while in the mode. Memo  By factory default, the time interval to enter the power saving mode is set to 1 minute. You can change the time interval by pressing the key on the operator panel and selecting [Admin Setup] > [Management] > [Power Save] > [Power Save Time].  Sleep Mode Your machine goes from the power saving mode into the sleep mode after a set period of time. In the sleep mode, the status of your machine is almost the same as when it is turned off. The key blinks while in the sleep mode. Note  The machine does not enter the sleep mode if an error occurs.  If time-set transmission is scheduled, the machine will not go into sleep mode.  If the fax transmission is waiting for a redial, the machine cannot enter sleep mode.  When the network connection is switched from wired to wireless, sleep mode is disabled. To enable sleep mode for devices connected using wireless LAN, enable sleep mode from the sleep mode setting menu. (MB451w and MB471w only)  When a device using the wireless LAN connection goes into sleep mode, the wireless LAN connection is broken. To reconnect to the wireless LAN, press the power save key on the device to recover from sleep mode. (MB451w and MB471w only)  After the device connected to the wireless LAN has recovered from sleep mode, it automatically connects to the wireless access point using the same settings as before it went into sleep mode. However, it may take up to 1 minute to connect. (MB451w and MB471w only)  When the network connection is switched from wireless LAN to wired LAN, sleep mode is enabled. (MB451w and MB471w only) Memo  By factory default, the time interval to enter the sleep mode is set to 30 minutes. You can change the time interval by pressing the key on the operator panel and then selecting [Admin Setup] > [Management] > [Power Save] > [Sleep Time].  Returning to the Standby Mode To return the machine to the standby mode from the power saving or sleep modes, press the key on the operator panel. Installing Your Machine Memo  When your machine receives a print job from a computer or other devices, it automatically returns to the standby 1 mode. Auto Power Off When your machine is not used for a certain period of time, the power turns off automatically. Once the machine turns off, you need to turn on to use it. The machine has three settings to select the machine's behavior on Auto Power Off. Enable Auto Config Disable Enable When your machine is not used for a certain period of time, it turns off the power automatically. Auto Config The machine will not turn off automatically under the conditions listed below. - An Ethernet cable is attached to network interface connection - A telephone cable is attached to LINE connection Disable The Auto Power Off function is disabled. The machine will not turn off automatically. Note  In the following cases, the Auto Power Off function is also disabled. - When an error occurs - When time-set transmission is scheduled - When the fax transmission is waiting for a redial - When [Auto Power Off] is [Auto Config.] and Ethernet cable is attached - When [Auto Power Off] is [Auto Config.] and telephone cable is attached Memo  By factory default, the time interval to turn off the power is set to 4 hours. You can change the time interval by pressing the key on the operator panel and then selecting [Admin Setup] > [Management] > [Power Save] > [Auto Power Off Time].  By factory default, [Auto Power Off] is set to [Auto Config] or [Disable]. You can change the setting by pressing the key on the operator panel and then selecting [Admin Setup] > [User Install] > [Power Save] > [Auto Power Off] - 21 -