Oki MB471 Users Manual Basic - Page 35

Setup 4 Adjust the manual feeding paper guide to the width of paper to be loaded. Loading Paper and Documents  Loading Paper in the Manual Feeder (MB441/MB461/ MB461+LP/ES4161 MFP) 1 The following procedure explains how to load paper in the Manual Feeder. 1 Open the Manual Feeder. 5 Insert the paper with the print side face up until its edge touches the paper feed entrance. Note  Do not load paper above the fill line (1). 1 2 Adjust the manual feeding paper guide to the width of paper to be loaded. 6 Press the Set button (2). 3 Load a paper. 2 Register the loaded paper on your machine. Proceed to "Configuring the Tray Settings". Note  Do not load paper of different sizes, types or weights at the same time.  When adding paper, remove the paper in the MP tray and straighten the edges of both stacks of paper, and then load them again.  Do not put anything other than paper for printing. Memo  When loading envelopes in the MP tray, load them face up with the orientation as stated below. - Your envelopes (Monarch, Com-9, Com-10, DL and C5) are loaded with the flap folded and the flap should come to the right side to the feeding direction. Note  Only one sheet can be set in the Manual Feeder each time.  The machine will not load paper when it is in the sleep mode or power save mode. If it is in either mode when you use the manual feeder, press the key on the operator panel. Then it goes to the standby mode. After that, load paper. - 35 -