Oki MB471 Users Manual Basic - Page 38

Loading Paper and Documents Keep the following in mind to avoid damaging the document glass:  Do not hold a document firmly on the glass when copying a thick document.  Place hard documents gently.  Avoid loading documents with sharp projections. Scannable Area The text or images on the shaded area shown below are not scanned. 2 mm  Loading Documents on the ADF 1 Load your documents face up on the ADF. If your documents are portrait, load them with the top edge of the documents in first. If your documents are landscape, load them with the left edge of the documents in first. 2 mm 2 mm 2 mm Memo  The arrow in the above drawing indicates the feeding direction in the auto document feeder, or the scanning start side on the document glass. Loading Documents Scanner Scannable Paper Paper type size capacity weight ADF Document glass  A4  A5  B5  A6*  Letter  Legal 13  Legal 13.5  Legal 14  Executive  A4  A5  B5  A6  Letter  Executive  Legal 13**  Legal 13.5**  Legal 14** 50 sheets 60 to 105 g/m2 (80 g/m2) (16 to 28 lb) - 20 mm Note  For documents using adhesives, ink, or correction fluid, set them after checking that these have completely dried.  Duplex scanning cannot be performed on paper indicated by an "*".  "**" supported only MB461+LP/MB491+LP/MPS4700mb. 2 Adjust the document guides to the width of your documents.  Loading Documents on the Document Glass 1 Lift and open the document glass cover. 2 Place a document face down on the document glass. If your document is portrait, align its top edge to the upper-left corner of the glass. - 38 -