Xerox 6180N Using LCDS Print Description Language - Page 165

Specifying input parameters Default EBCDIC VOLUME CODE parameter: points to note • When you run a CODE=NONE job with DUPLEX=YES and SHIFT=YES, you must specify MARGIN in inches. • Input data is translated according to the CODE selected on the VOLUME command. Any character that is translated into an ASCII X'20' is truncated after the last significant (nonASCII X'20') character in the print record. • On the FreeFlow Print Server LCDS systems, trailing spaces are deleted for the current code set only. In addition, translated characters that are beyond the highest character code in the current font are converted to blanks and potentially removed. VOLUME DBCODE Specifies which double-byte character code translation table the system will use to interpret the input data. Syntax VOLUME DBCODE = {keyword | id } Options Table 2-59. VOLUME DBCODE parameter options and definitions Option Definition keyword Specifies a specific, standard, system defined double-byte code translation table. The available options are: • IBM: IBM Nihongo character set (Kanji double-byte character sets) • IBMCHN: IBM 5550 code translation table • JEF: Fujitsu JEF Kanji double-byte character set • KEIS: Hitachi KEIS Kanji double-byte character set • USER: Refers to the single unlabeled DBCODE command defined within the JDL or JDE. id Specifies an identifier label that was used in a previously defined DBCODE command to refer to a specific, user-defined code translation table. The id label is required when multiple DBCODE commands are contained within the JDL. Default No default Using LCDS Print Description Language 2-57