Xerox 6180N Using LCDS Print Description Language - Page 395

Using Dynamic Job Descriptor Entries (DJDEs)

Using LCDS Print Description Language

5-41

GRAPHIC DJDE: points to note

•

Other than

name

, none of the parameters may be used if the

specified graphic is document interleaved, nor should

name

normally be used if the graphic is referenced by an IMAGE

DJDE.

If the graphic is page interleaved, the remaining parameters

may be used exactly as on the IMAGE DJDE (except for the

T parameter). If these parameters are specified in the

GRAPHIC DJDE and also on one or more IMAGE DJDEs

that reference the same graphic, the graphic is imaged on the

page once for each reference.

•

Document and page interleaved graphics:

If no textual

data has been previously encountered, the graphic specified

in the GRAPHIC DJDE is document interleaved and is copied

to a .IMG type disk file.

If textual data has been encountered previously, the graphic

is page interleaved and the previous print record should have

caused a page transition. If not, the occurrence of this DJDE

forces an immediate page termination, and the next print

record encountered is processed relative to TOF (Top of

Form) on the next physical page.

An interleaved graphic that immediately follows a header

banner page is treated as document interleaved. The header

banner page must be defined by a BANNER command. Skip

carriage control commands on a graphics sentinel DJDE are

ignored.

•

Graphic file replacement and deletion:

If an image file with

the specified name already exists in the “lcds” resources

directory, it is superseded by the new one. However, it is not

replaced immediately. If a new file will be retained beyond the

scope of the current report processing (as indicated by the

OUTPUT PURGE parameter or the SAVE DJDE), the new

file is stored in (and replaces existing files in) the “lcds”

resource folder when processing of the report is complete.

NOTE:

The “lcds” folder can be accessed from either of the

following Unix directory paths:

/var/spool/XRXnps/resources/lcds/

or

/opt/XRXnps/resources/lcds/

Section	Page
Language	1
Print Server version 6.0	1
June 2007	1
701P47156	1
Xerox FreeFlow® Print Server	1
Using LCDS	1
Print Description	1
Table of contents	3
Laser safety xvii	3
Introduction xxiii	3
1. PDL principles and procedures 1-1	3
2. Specifying input parameters 2-1	4
3. Using logical processing 3-1	7
4. Specifying print format parameters 4-1	9
5. Using Dynamic Job Descriptor Entries (DJDEs) 5-1	11
6. Using PDL commands for graphics 6-1	14
A. PDL command and DJDE summary A-1	14
B. PDL command quick reference B-1	14
C. Character code assignments C-1	14
D. Offline specifications D-1	14
Glossary Glossary-1	15
Symbols	495
Numerics	495
A	495
B	495
C	496
D	497
E	497
F	498
G	498
H	498
I	499
J	499
K	500
L	500
M	500
N	501
O	501
P	502
R	502
S	503
T	504
U	504
V	504
W	505
X	505

Xerox 6180N Using LCDS Print Description Language - Page 395

GRAPHIC DJDE: points to note, Document and interleaved graphics, Graphic file replacement

Page 395 highlights