Xerox 6180N Using LCDS Print Description Language - Page 417

Using Dynamic Job Descriptor Entries (DJDEs) Syntax RTEXT = {NONE | sc | (sc [, {passnum | ALL} [, line [, col [, fontindex]]]]) | rtextid} Options Table 5-52. RTEXT DJDE options and definitions Option Definition sc string constant Specifies the message to be printed (a string of 1 to 132 characters). It is printed with the first font specified in the FONTS parameter of the PDE command. Refer to the fontindex option in this table. passnum pass number An integer specifying the single copy (pass) to which the text applies. If there are two or more RTEXT parameters in a ROUTE command, passnum must be in increasing numeric order. ALL Specifies that the text applies to all copies. line Specifies the line number on which the first line of a block of RTEXT message is printed. To avoid overprinting, only one RTEXT parameter may be specified per line for a passnum. The default is line 1 for the first text string of the pass. Otherwise, the default is the next line of the page. col column. Specifies the column number at which the first character of a block of RTEXT messages is to be printed. The default is column 1. fontindex Identifies the index (starting with 1) of the PDE font with which the text is printed. rtextid route text identifier Used to reference a catalogued file of RTEXT parameters previously compiled by XJDC. A file of the type .TST is referenced. NONE Specifies that no text is to be printed on a separate page. RTEXT DJDE example RTEXT=('TEST',ALL,15,5,2); END; Using LCDS Print Description Language 5-63