Xerox 6180N Using LCDS Print Description Language - Page 324

Specifying print format parameters OUTPUT SYSPPR parameter: points to note • PAPERSIZE=B4 and PAPERSIZE= (10.12, 14.33) produce identical results in that they indicate long edge feed, as opposed to short-edge feed format. Refer to the "SEFFNT command" section in the "Specifying input parameters" chapter for detailed information on short and long-edge feed. • The SYSPPR parameter takes effect for the following system pages: - DJDE error page (OPRINFO parameter of the IDEN command) - Report delimiter page (PRINT parameter of the RSTACK command) - Accounting page (ACCT command) - Graphic error summary page - Short Edge Feed error page • SYSPPR and the STOCKSET SYSPAGE parameter: System pages are checked for stocks through the SYSPAGE parameter. If there is no stock name active for the current page, the system checks to see if a stock name was specified at the user interface on the Stock tab of the queue Properties window. If so, the system page is printed on the stock that is specified on the user interface window. If SYSPAGE=stock is not specified, the MAIN stock definition is used. SYSPPR defines the paper size to use for the system page. Therefore, if MAIN contains a mix of USLETTER and USLEGAL, the system searches for the appropriate feeder tray that contains the required paper size. If SYSPPR is not defined, the printer uses the paper size of the current job. NOTE: SYSPPR defines a paper size, whereas SYSPAGE defines a stock name reference. Both parameters must agree in order to prevent errors, similar to the way the FEED and PAPERSIZE parameters interact. 4-84 Using LCDS Print Description Language