Xerox 6180N Using LCDS Print Description Language - Page 303
OUTPUT LOGO, Syntax, Options, Default, Table 4-62. OUTPUT LOGO parameter options and definitions
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 303 highlights
Specifying print format parameters OUTPUT LOGO Allows you to specify a logo for imaging on all pages of a report, unless it is canceled by a CANCEL DJDE. Up to 128 logos can be specified on a page. Syntax OUTPUT LOGO = (name, vpos units, hpos units [, INKS, inkindex1 [, inkindex2])]) Options Table 4-62. OUTPUT LOGO parameter options and definitions Option name vpos hpos units INKS inkindex Definition Name of the logo file vertical position A value constant that specifies as an offset the vertical position of the top edge of the logo relative to the 0,0 position on the current physical page (the position that would be specified by a PDE BEGIN parameter value of 0,0). horizontal position A value constant that specifies as an offset the horizontal position of the left edge of the logo relative to the 0,0 position on the current physical page. The unit of measurement for the vertical and horizontal positions offset value. Options are: • DOTS • XDOTS (600 dpi dots) • CM (centimeters) • IN (inches) The default unit is IN. Indicates that the ink that follows will override the inks that are defined in the logo. Overrides the corresponding inks that are specified in the ink list of the logo. NOTE: For this option to be valid, the logo that is referenced must be in color format. Default No default Using LCDS Print Description Language 4-63