Xerox 6180N Using LCDS Print Description Language - Page 256
CME INK, parameter: points, to note, CME LINE, Syntax, Options, Default, parameter: point, ascending
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 256 highlights
Specifying print format parameters CME INK parameter: points to note • If 0 is specified (or defaulted) for the INK parameter, the ink for the variable data and the CME text reverts to the ink that was specified in the IDFAULT parameter of the OUTPUT command. • An inkindex value greater than the ILIST size causes an "out of range" message to be displayed. The operator has the option to continue printing the job using black ink or to abort the job. CME LINE Specifies the line range within which the CME is located on the page. Syntax ac: CME LINE = {n | (n, m) | (n, -)} Options Table 4-18. CME LINE parameter options and definitions Option Definition n The initial line number of the copy modification rectangle m The number of lines to repeat the information. If not specified, the information applies only to the starting line. - A dash character indicates that information is to apply to all lines on a page beginning with the line indicated by n. Default No default. CME LINE parameter: point to note The line numbers specified in the LINE parameter must always be in ascending order. In other words, you cannot specify one line number, then list another one of lower value in the same command. For example, the following command is incorrect and will not be compiled: CME1: CME LINE =(2,3), POS=15, CONSTANT=(6),'HELLO', FONTINDEX=3, LINE=1, POS=15; As you can see, the first line parameter specifies starting at line 2, while the second LINE parameter specifies line 1, which contradicts the ascending order. 4-16 Using LCDS Print Description Language