Xerox 6180N Using LCDS Print Description Language - Page 398

Using Dynamic Job Descriptor Entries (DJDEs) Options Table 5-33. ILIST DJDE options and definitions Option Definition 'inkname' Specifies an ink name that will be part of the ILIST that is defined for the page. Note that the ink name is specified within single quotes. ILIST DJDE example ILIST = ('BLACK', 'XEROX.RED') IMAGE DJDE In Batch mode, this DJDE defines new imaging parameters for subsequent graphics. In all other modes, it defines imaging parameters for the named graphic. Type Record oriented Syntax IMAGE = (imgname, vpos [units], hpos [units] [,T] [,H] [, n / [d]] [, (INKS, inkref1 [, inkref2])]) Options Table 5-34. IMAGE DJDE options and definitions Option Definition imgname image name The name of an .IMG file or the name on the DJDE sentinel record of a page interleaved graphic immediately following the current page, such as GRAPHIC=name). Lowercase characters a through z are converted to uppercase. The name parameter may be omitted in Batch mode; however, the comma before vpos must be coded, because it is a positional parameter. vpos vertical position. Specifies the vertical position of the top edge of the graphic as a downward offset relative to 0,0 on the current physical page. (This is the position that would be specified by a PDE BEGIN of 0,0 and a PDE PMODE value, PORTRAIT or LANDSCAPE, that is currently in effect). Specified as a decimal number with up to three digits to the right of the decimal point and may be followed by a space and the units indicator. NOTE: The default value for the vpos parameter is 0. 5-44 Using LCDS Print Description Language