Xerox 6180N Using LCDS Print Description Language - Page 338
PDE FONTS, Syntax, Options, Default, Table 4-85. PDE FONTS parameter options and definitions
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 338 highlights
Specifying print format parameters • The placement of the values of the BEGIN parameter on the FreeFlow Print Server LCDS systems, 4850 LPS, 4890 LPS, and DP92C LPS is relative to the top edge of the physical sheet for all paper sizes. On the 4635 and DP180 LPS, however, an A4 paper size specification causes the image to shift approximately 1/8 inch (3 mm) downward. If you want to provide consistency between jobs that are printed on the FreeFlow Print Server LCDS systems and on a 4635 or DP180 LPS, you can adjust the alignment by 35 dots using the FreeFlow Print Server LCDS systems queue management windows. Refer to the "Adjusting alignment" section of your printer operator guide for this procedure. PDE FONTS Specifies the fonts to be used in printing variable input data and CME data. Syntax ac: PDE FONTS = {(f1 [, f2 f1, s1 [, unit]) [, (f2, s2 [unit Options Table 4-85. PDE FONTS parameter options and definitions Option Definition f font. Specifies a one to six alphanumeric character identifier (consisting of at least one letter) corresponding to a font cataloged on the system disk (you can use up to 128 fonts with the font indexing capability). s spacing. Specifies an optional override line spacing value defined by either the print lines per inch (LPI) or the dots per print line (DOTS or XDOTS) to be associated with the font. Maximum value for s is 30 LPI; minimum value is 10 dots. There is no default LPI value for s. unit A unit of measure for the override line spacing to be associated with a font. The unit can be one of the following: • LPI (lines per inch) • DOTS (dots per print line at 300 dpi) • XDOTS (dots per print line at 600 dpi) The default unit is LPI. Default No default 4-98 Using LCDS Print Description Language