Xerox 6180N Using LCDS Print Description Language - Page 406
LOGO DJDE: points to note, LPI DJDE, Syntax, Options, Table 5-42. LPI DJDE options and definitions
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 406 highlights
Using Dynamic Job Descriptor Entries (DJDEs) LOGO DJDE: points to note • Any logos specified in a selected JDE (the JDE that was specified in the JDE DJDE) replace those from the original JDE. If none are specified in the selected JDE, logos from the original JDE are canceled. • If the logo that is specified in the Initial JDE is not found, the job aborts and an error message is displayed. If a logo that is specified after the start of the job is not found, the system response is determined by the specifications in the ABNORMAL ERROR parameter. • The HERE keyword must be included whenever the VADJ or HADJ options are coded. Otherwise, a syntax error occurs. • If inks are used: - If one inkref in the list is omitted, commas must be used as place holders to maintain the relative positioning of the remaining ink references. - If more than two ink references are specified, the additional ink references are ignored. LPI DJDE Specifies the values for the vertical spacing between subsequent lines. Type Record oriented Syntax LPI = {(linespacing [units], DEFAULT) | (linespacing [units], lineno, (...))} Options Table 5-42. LPI DJDE options and definitions Option Definition linespacing lines per inch Specifies the line spacing value. May be measured in: units Unit of measure for the amount of vertical line space. The options are: • LPI (lines per inch) • DOTS • XDOTS (600 dpi) The default unit is LPI. 5-52 Using LCDS Print Description Language