Xerox 6180N Using LCDS Print Description Language - Page 325

Specifying print format parameters OUTPUT TMODE Specifies a maximum paper width in order to improve throughput efficiency when mixed paper sizes are used. Refer to "Paper sizing and print speed" in your printer operator guide for an explanation of the relationship between paper widths and throughput speed. Syntax OUTPUT TMODE = {width | (width [,widthunit])} Options Table 4-77. OUTPUT TMODE parameter options and definitions Option Definition width The process direction measurement that will be used to determine the pitch mode. • For normal (long-edge) feeding, this is normally a measure of the short edge of the widest paper being used in the report. • For short-edge feeding (SEF) this measures the long edge of the sheets. Acceptable values range from the system minimum to the system maximum (usually specified at system installation). widthunit Defines the unit of measurement for the default pitch mode. Choices are: • IN • CM • DOTS • XDOTS. IN (inches) is the default widthunit. Default Based on the specified paper size (expressed in inches) OUTPUT TMODE parameter: points to note • This feature is not supported for the Nuvera MX systems. • Width values can range from 7 inches or 178 mm to 17 inches or 432 mm. • In order to process 7 by 10 inch and B5 papers, the printer must be configured with the 7 by 10 inch throughput kit (a hardware option). Using LCDS Print Description Language 4-85