Xerox 6180N Using LCDS Print Description Language - Page 416

Using Dynamic Job Descriptor Entries (DJDEs) Options Table 5-51. RFORM DJDE options and definitions Option Definition formid form identifier. Name of the form to be printed with all RTEXT pages. References a previously created form file (FILENAME.FRM). NONE Specifies that no form will be printed with RTEXT pages. INKS Specifies that the inks that follow will be used for the forms. inkref Identifies the inks that override the corresponding inks that are specified in the ink list of the form. If a form does not contain an ink list, the form is printed in black. RFORM DJDE: points to note • The RFORM parameter is not allowed in a ROUTE command that is being defined as a catalogued file. However, you may specify it in the ROUTE command in the JSL invoking the catalogued RTEXT file, or you can specify it via the RFORM DJDE. Refer to the "ROUTE RTEXT" parameter section in the "Specifying print format parameters" chapter for further details. • Forms may be created using forms creation software on a workstation, or by compiling a file of forms source commands, called an FSL, with the FDL compiler on another type of LPS. • For colored forms: If an inkref that is on the ink list is omitted from the command, commas must be used to maintain the relative positioning of the remaining ink references. If more than two inkrefs are specified, the system ignores the additional inkrefs. RTEXT DJDE Specifies text to be printed on a separate page preceding a report. It takes effect on the next page boundary. The parameters for the RTEXT DJDE are the same as for the ROUTE RTEXT command. Type Page oriented 5-62 Using LCDS Print Description Language