Xerox 6180N Using LCDS Print Description Language - Page 300

Specifying print format parameters OUTPUT IMAGE This parameter is for Batch mode processing only, and specifies the initial graphic imaging parameters to be used. Syntax OUTPUT IMAGE = (vpos [units], hpos [units] [, n [/d]] [, (INKS, inkref1 [, inkref2])]) Options Table 4-59. OUTPUT IMAGE parameter options and definitions Option vpos hpos units n / d INKS inkref Definition vertical position. Specifies the vertical position of the top edge of the graphic, as a downward offset, relative to 0,0 on the current physical page (the position that would be specified by a PDE BEGIN of 0,0). This parameter is specified as a decimal number with up to three digits to the right of the decimal point and may be followed by a space and the units indicator. horizontal position. Specifies the horizontal position of the left edge of the graphic, as a rightward offset, relative to 0,0 on the current physical page. The form of the specification is the same as for vpos. Specifies the unit of measure for the vertical and horizontal positions of the image on the page. • DOTS • CM (centimeters) • IN (inches) • UN (user defined unit). The default unit is IN. numerator / denominator. Specifies the reference scale factor. Each parameter, n and d, must be an integer in the range of 1 to 8, thereby allowing a reference scale factor in the range of 1/8 to 8. The reference scale factor is multiplied by the scale factor specified at the time the graphic was digitized and the product is rounded to the nearest integer in the range 1 to 8. That integer becomes the effective scale factor with which each pixel of the graphic is imaged. If n is specified but not d, d is assumed to be 1. Specifies that the ink references that follow will override the inks that were defined in the image file. ink reference Specifies the inks that override the corresponding inks specified in the ink list of the image file. 4-60 Using LCDS Print Description Language