Xerox 6180N Using LCDS Print Description Language - Page 305

Specifying print format parameters OUTPUT MODIFY parameter: points to note • A CME may be coded within a JSL or coded and catalogued separately for use by several JSLs. Any CME invoked by a DJDE must be catalogued separately. Refer to the "CME command" section earlier in this chapter for further information. • If the CME is within the JSL, it must precede a reference to its identifier by the MODIFY parameter. • Different CMEs may be associated with different copies of a report by the use of multiple MODIFY parameters on the same OUTPUT command. CME copy ranges may not overlap. • If different CMEs are associated with different copies of a report, or if a CME is applied to some but not all copies of a report, then the CMEs are termed copy sensitive. Copy sensitive CMEs may not be used if COLLATE=NO, or online processing is specified. Refer to the MODIFY DJDE section in the "Using Dynamic Job Descriptor Entries (DJDEs)" chapter for a discussion of how CMEs may be changed on a page by page basis within a report ply. OUTPUT NTO1 Specifies, on a report basis, whether all copies of a particular report are printed last page to first (n to 1). Syntax OUTPUT NTO1 = {NO | YES | n} Options Table 4-64. OUTPUT NTO1 parameter options and definitions Option YES NO Definition Specifies last to first page printing. To print n to 1, output processing must print the report starting with the last page. Therefore, output processing cannot begin until input processing has finished with the entire report. It is possible that input processing does not recognize the end of a report until it detects the start of the next report (header banner page). When YES is specified, the system assumes a 50 sheet threshold for the maximum report size to be printed N to 1. Specifies first page to last (1 to n) printing. Using LCDS Print Description Language 4-65