Xerox 6180N Using LCDS Print Description Language - Page 291
Cycleforms And Forms
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 291 highlights
Specifying print format parameters Options Table 4-48. OUTPUT CYCLEFORMS parameter options and definitions Option NONE formid INKS inkref Definition Specifies that no form will be added to the associated report page of variable data. Specifies a 1 to 6 character form file name (may be numeric, alpha, or alphanumeric), which exists on the system disk. Specifies that the inks that follow will be used for the forms. Identifies the inks that override the corresponding inks that are specified in the ink list of the form. If a form does not contain an ink list, the form is printed in black. Default NONE OUTPUT CYCLEFORMS parameter: points to note • If multiple CYCLEFORMS are specified in the same OUTPUT command, a single list consisting of all these specified forms is created. The forms are listed in the order the names are encountered. The number of form identifiers is limited only by the number of forms retained on the disk. • CYCLEFORMS and FORMS: Both may be used within a report; however, only the parameter that was specified most recently is in effect at any given time. If a multicopy report specifies CYCLEFORMS, a FORMS DJDE that is encountered in the report overrides the CYCLEFORMS parameter from that point in every copy. • For colored forms: If an inkref that is on the ink list is omitted from the command, commas must be used to maintain the relative positioning of the remaining ink references. If more than two inkrefs are specified, the system ignores the additional inkrefs. OUTPUT CYCLEFORMS parameter example OUTPUT CYCLEFORMS=(form1, form2) Using LCDS Print Description Language 4-51