Xerox 6180N Using LCDS Print Description Language - Page 405
Table 5-41. LOGO DJDE options and definitions Continued
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
Using Dynamic Job Descriptor Entries (DJDEs) Table 5-41. LOGO DJDE options and definitions (Continued) Option units H HERE HADJ VADJ + | - tvalue INKS inkref Definition Specifies the unit of measure for the vertical and horizontal positions of the logo on the page. Available units are: • DOTS • CM (centimeters) • IN (inches) • UN (user defined unit) • XDOTS (DOTS at 600 spi) If UN is specified, the user defined positioning unit must be previously defined by the OUTPUT UNITS command in the current JDE or JDL. The default positioning unit is IN. HOLD Specifies that the logo that is invoked by the DJDE will be held and imaged without further callouts and at the same position on all subsequent pages until it is canceled by a CANCEL DJDE. A logo that is specified in a DJDE appears only on the current page unless the H option is specified. NOTE: If any character other than H, or any additional character, is detected in the fourth parameter position of this command, the system declares a syntax error. Specifies that the upper left corner of the logo will be positioned at, or relative to, the top of the next printed line, and the current left margin. HORIZONTAL ADJUSTMENT Specifies that an adjustment will be made to the horizontal position of the left edge of the logo, relative to the position defined by the HERE option. VERTICAL ADJUSTMENT Specifies that an adjustment will be made to the vertical position of the left edge of the logo, relative to the position defined by the HERE option. Specifies a positive or negative positioning of the tvalue. When following HADJ, + shifts the logo to the right, and - shifts it to the left. When following VADJ, + shifts the logo downward on the page and - shifts it upward. Specifies the amount of the adjustment signaled by the HADJ or VADJ parameter for a logo on the page. May be specified in inches (IN), centimeters (CM), user defined units (UN), DOTS, or XDOTS (600 spi dots). The default unit is IN. Specifies that the ink references that follow will override the inks that were defined in the image file. ink reference Specifies the inks that override the corresponding inks specified in the ink list of the image file. Using LCDS Print Description Language 5-51