Xerox 6180N Using LCDS Print Description Language - Page 307

Specifying print format parameters • NTO1 and OSTK: When printing ordered stock in NTO1 sequence using the OSTK parameter, note the following: The ordered stock must be reverse collated in the feeder so that the first sheet of the set is on the bottom, the second sheet next to the bottom, and so on, with the last sheet of the set on top to be fed first. If the report is larger than the N to 1 threshold, it prints in 1 to N order, and the reverse collated stock is then inappropriate. When this occurs, the system displays a message stating that page ordering has been reversed, and cycles down. • NTO1= NO, FACEUP= NO, and DUPLEX= NO: In this sequence, the NTO1 and FACEUP parameters specify the NO option so other potentially affected parameters, such as DUPLEX, are not overridden. The DUPLEX parameter, therefore, maintains either the YES or NO option. If hierarchical overrides occur, the system issues warning messages in the xjdc listing when the JSL is compiled, then forces parameters that are lower in the hierarchical structure to their workable values. OUTPUT NUMBER Invokes page numbering on the printed report, and specifies starting number and location of the numbers on the page. Syntax OUTPUT NUMBER = {(pnum, lnum, cnum [, [findex] [, inkref]]) | NO} Options Table 4-65. OUTPUT NUMBER parameter options and definitions Option pnum lnum cnum Definition page number An integer specifying the number with which page numbering starts. The beginning page number may be nonpositive. The number is incremented at page transitions but is not printed until it becomes positive. The maximum page number that can be printed is 2,147,483,647. line number. An integer specifying the number of the line on which the page number is placed. column number. An integer specifying the ending column number for the page numbering sequence. Using LCDS Print Description Language 4-67