Xerox 6180N Using LCDS Print Description Language - Page 272
Line Overprint
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 272 highlights
Specifying print format parameters Default No default LINE LPI parameter: points to note • If the LARGE[ST] is specified for the LINE BASELINE parameter, the LPI parameter is ignored. • The line spacing value is not based on the maximum LPI font of the line. Instead, it is based on the value that is specified in the command: LINE LPI = LINESPACING LINE MARGIN Specifies the left printing margin within each logical page. Syntax LINE MARGIN = {value | (value, valuetype)} Options Table 4-34. LINE MARGIN parameter options and definitions Option Definition value Specifies the distance from the left edge of the logical page (as indicated by the current BEGIN value in effect) to the left margin. Has the format nnn.mm (a positive decimal number of up to three digits, with up to 2 digits to the right of the decimal point). valuetype Unit of measure for the margin value. Available unit options include: • IN (inches) • CM (centimeters) • POS (character positions). NOTE: When you run a CODE=NONE job with DUPLEX=YES and SHIFT=YES, you must specify MARGIN in inches. Default (1, POS) LINE MARGIN parameter: point to note A value must be specified as an integer (nnn) if its valuetype is character positions (POS). LINE OVERPRINT Specifies how overprint lines are handled. (Overprint lines are print lines whose carriage control specifies printing with no line spacing after the last printed line.) Syntax LINE OVERPRINT = (overopt, disp) 4-32 Using LCDS Print Description Language