Xerox 6180N Using LCDS Print Description Language - Page 394

Using Dynamic Job Descriptor Entries (DJDEs) Options Table 5-29. GRAPHIC DJDE options and definitions Option Definition name vpos Identifies the graphic. If document interleaved, it becomes the file name with which the .IMG file is written. If page interleaved, it is used to associate the graphic with other DJDE references. vertical position. Specifies the amount of vertical spacing of the top edge of the graphic from 0,0 on the physical page. hpos units H n/d INKS inkref horizontal position. Specifies the horizontal spacing of the left edge of the graphic from 0,0 on the current physical page. Unit of measure for the vertical and horizontal positions of the graphic. The following may be used: • UN (unit defined by the user) • CM (centimeters) • IN (inches) • DOTS • XDOTS (DOTS for 600 spi processing) If UN is specified, the user defined positioning unit must be previously defined by the OUTPUT UNITS command in the current JDE or JDL. The default positioning unit is IN. HOLD Specifies that the same graphic is to be held and imaged without further callouts at the same position and with the same scale factor at all subsequent pages until changed by a DJDE CANCEL or ALTER DJDE. numerator/denominator Specifies the reference scale factor. Each option, n and d, must be an integer in the range of 1 to 8, thereby allowing a reference scale factor in the range of 1/8 to 8. The reference scale factor is multiplied by the internal scale factor of the image. Specifies that the ink references that follow will override the inks that were defined in the image file. ink reference Specifies the inks that override the corresponding inks specified in the ink list of the image file. 5-40 Using LCDS Print Description Language