Xerox 6180N Using LCDS Print Description Language - Page 310
OUTPUT OFFSET, parameter: point, to note, OUTPUT OSTK, Syntax, where, Options, Table 4-67. OUTPUT
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 310 highlights
Specifying print format parameters OUTPUT OFFSET parameter: point to note The OFFSET control of FIRST, ALL, or NONE may be modified by the ROFFSET command. Refer to the "ROFFSET" command section in the "Using logical processing" chapter. If OUTPUT OFFSET=FIRST (or ALL) was specified, and the ROFFSET criteria is satisfied on the first page of a report, the normal offset from the preceding report occurs. OUTPUT OSTK Specifies that ordered stocks are used for printing the job. Syntax OUTPUT OSTK = {ostkspec | (ostkspec, ostkspec, ...)} where ostkspec is: (stockdef, [mod], [pos], [{RES | NORES}], [TABS], [size {DOTS | IN | CM}]] [, {L | P}]) Options Table 4-67. OUTPUT OSTK parameter options and definitions Option Definition stockdef stock definition The identifier or name of the ordered stock to be used, and for which feeder trays have been identified on the user interface Stock List. No default. mod modulus The number of sheets in the ordered stock. For example, 5 cut tabs would have a mod value of 5. The range of values is from 1 to 255. The default modulus definition is 1. pos position. The initial position relative to the mod value. The range of values is between 1 and mod. The default position is 1. RES NORES RESET or NO RESET. Indicates whether the pos value should be reset at the start of the next report. The default is RES. TABS Indicates a tab stock is being used. The default is no tabs (no option entered). size Width of the tab. The value can be specified in DOTS, IN, or CM. This parameter applies only when tabs are specified. The default is 0.5 in. 4-70 Using LCDS Print Description Language