Xerox 6180N Using LCDS Print Description Language - Page 373

Using Dynamic Job Descriptor Entries (DJDEs) Options Table 5-11. BFORM DJDE options and definitions Option Definition NONE formid Specifies that no form will be added to the associated report page of variable data. When NONE is specified in combination with other BFORM options, it takes precedence over the other BFORM options, so that no forms are printed. form identifier Specifies a filename for a form that exists on disk. This form file is created with forms creation software on a workstation or with Forms Description Language (FDL) on another type of LPS. init copies INKS initial copy Specifies the first copy number to which a specified form applies. NOTE: For the DP 2000 Series EPS, any init specification greater than 1 is ignored. The form that appears on the first copy appears on all subsequent copies. Specifies the number of plies (passes) to which a specified form applies. Default is all copies of the report. Indicate that ink references follow. inkref ink reference Identifies an ink that overrides the corresponding ink specified in the ink list of a colored form. If the form does not contain an ink list, the form is printed in black. NOTE: If one ink reference from the ink list is omitted, a comma must be used in its place in order to maintain the relative positions of the remaining ink references. If more ink references are specified than the number of inks in the ink list, the extra inkrefs in the DJDE are ignored. BFORM DJDE: points to note • Multiple BFORM DJDEs may be specified to place different BFORMS on different copies. • Multiple instances of the BFORM DJDE right part syntax (shown in the Syntax section for this DJDE) may be provided enclosed in parentheses and separated by commas. For example: BFORM=(bform1, bform2, bform3); or BFORM= ((bform1, 1, 2),) (bform2, 3, 1)); The following syntax specifies that no back form will be added to any copy: BFORM=(bform1, NONE, bform3) Using LCDS Print Description Language 5-19