Xerox 6180N Using LCDS Print Description Language - Page 424

Using Dynamic Job Descriptor Entries (DJDEs) STOCKS DJDE Identifies the stock set and its associated stock(s) to be used in a report. This stockset file (STOCKSETNAME.STK) must already have been created by a compiled JSL and must currently reside in the "lcds" resource folder on the system disk. Type Page oriented Syntax STOCKS = stocksetname Options Table 5-59. STOCKS DJDE options and definitions Option stocksetname Definition Name of the STOCKSET used in a report. STOCKS DJDE: point to note Whenever a new stockset is chosen, that is, at start of report or through a JDE or JDL switch via DJDE, the system verifies each stock to determine that the stock exists and can be made active. This verification provides an automatic method of changing stocks in the printer as required by the data stream. TMODE DJDE Specifies a maximum paper width in order to improve throughput efficiency when using mixed paper sizes. Refer to the "OUTPUT TMODE" parameter section in the "Specifying print format parameters" chapter for an explanation of pitch mode. NOTE: This feature is not supported by the Nuvera MX series printers. Type Page oriented Syntax TMODE = (width [, widthunit]) 5-70 Using LCDS Print Description Language