Xerox 6180N Using LCDS Print Description Language - Page 426
TRANS DJDE, Syntax, Options, TRANS DJDE: points to note, Table 5-62. TRANS DJDE options
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 426 highlights
Using Dynamic Job Descriptor Entries (DJDEs) For example, if the initial TOF and BOF values are 2 for every job, a page transition occurs every time a data record is processed because the TOF and BOF have the same value. If a TOF DJDE specifying a value of 1 is processed and the page transition has already occurred, the TOF DJDE value is too late and does not take effect until the next page transition. • The value option is defined the same as in the VFU command, described in the "Specifying print format parameters" chapter. • If the value specified in the TOF DJDE is greater than or equal to the BOF (Bottom Of Form) value, the TOF value is set to 1. TRANS DJDE Specifies whether or not transparencies are used in the print job. Type Page oriented Syntax TRANS = {YES | NO} Options Table 5-62. TRANS DJDE options and definitions Option Definition YES Specifies that transparencies are used in the print job. NO Specifies that transparencies are not used in the print job. TRANS DJDE: points to note • The TRANS DJDE is used to force parameters when transparencies are used and to minimize paper jams. If TRANS=YES is specified, the following parameters are forced: - DUPLEX=NO - ACCT=TRAY - BFORM is ignored. - For the RPAGE command, the NUBACK parameter is forced to NUFRONT. 5-72 Using LCDS Print Description Language