Yamaha AW16G Owner's Manual - Page 11
Removing the CD-RW drive, Using the CD-RW drive
View all Yamaha AW16G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Before you start Removing the CD-RW drive 1 4 3,5 CD-RW drive cover 1 Turn off the power of the AW16G. As described in "Turning the power off (shut down)" (→ p. 12), turn off the power of the AW16G. For safety's sake, also unplug the AC adaptor and the AW16G from the electrical outlet. 2 Turn the AW16G over on its face. Be careful not to drop the AW16G on the floor, or damage the components of the top panel. 3 Remove the CD-RW drive cover. Remove the black screw that holds the CD-RW drive cover in place ("3" in the diagram at left). Do not lose the screw that you removed. 4 Pull the CD-RW drive out of the slot. Remove the two screws that fasten the CD-RW drive in place, and pull out the CD-RW drive ("4" in the diagram at left). Grasp here with your thumb and first finger. < Bottom of the CD-RW drive > The cover may crack if you attempt to pull out the CD-RW drive by grasping the black cover. • Do not lose the screws that you removed. • Be careful not to cut yourself on any sharp metal edge. 5 Attach the CD-RW drive cover. Using the black screw that you removed in step 3, attach the CD-RW drive cover. Using the CD-RW drive The CD-RW drive installed in the AW16G is shipped with a protective pad on the disc tray to prevent it from being damaged during transportation. Before you use the AW16G, you must remove this protective pad. To insert a disc into the CD-RW drive, press the eject switch. The disc tray will open. Place the disc on the tray, and gently push the disc tray in. Note The disc tray is ejected electrically. If the disc tray is not ejected when you press the eject switch, turn on the power of the AW16G and press the eject switch once again. Eject hole Eject button ■ Removing a CD in an emergency If you are unable to remove the disc by pressing the eject switch, insert a wire of less than 2 mm diameter (such as a straightened paper clip) into the eject hole, and push gently. However, pressing the eject switch will not eject the disc when the AW16G is in the following states, so do not use this method in such cases. • When the AW16G's power is "STANDBY" • When the disc is being accessed (data is being read, written, or erased) • While in CD PLAY mode This removal method is for use in emergencies such as when you cannot remove the disc due to a malfunction of the disc tray or a power failure. Do not use this method unnecessarily, since doing so will damage the CD-RW drive. 11