Yamaha AW16G Owner's Manual - Page 170
Recording audio data from an MD recorder, Move the cursor to the DIGITAL REC ON/OFF
View all Yamaha AW16G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Using the AW16G with external devices To play back your MD recorder and listen to the recorded result, connect the DIGITAL STEREO OUT jack of your MD recorder to the AW16G's DIGITAL STEREO IN jack, and perform the following steps. 7 If you want to hear the result that was recorded on the MD recorder, lower the [STEREO] fader to the -∞ position, and use the [UTILITY] key to access the D.IN - HDD page of the UTILITY screen. 8 Move the cursor to the DIGITAL REC ON/OFF button, and press the [ENTER] key. A message will ask you to confirm your observance of copyright laws. If you accept the conditions described in "Copyright Notice" (→ p. 5), move the cursor to the OK button and press the [ENTER] key. The DIGITAL REC ON/OFF button will be switched ON, and digital audio data input will be enabled. 9 Move the cursor to the DIGITAL PATCH IN field, and turn the [DATA/JOG] dial to select "STEREO BUS" as the destination for the input signal from the DIGITAL STEREO IN jack. With this setting, the input signal from the DIGITAL STEREO IN jack will be connected directly to the stereo bus. Note Please note that the EQ and dynamics settings you made for the stereo output channel during mixdown are still valid at this point. If necessary, turn off EQ and dynamics. 10 Raise the [STEREO] fader to the 0 dB position, and play back your MD recorder. Recording audio data from an MD recorder Here's how the signal from an MD recorder connected to the DIGITAL STEREO IN jack can be recorded on an AW16G track while still in the digital domain. 1 Lower the [STEREO] fader to the -∞ position. 2 As shown in the diagram below, connect your MD recorder to the AW16G. MD recorder DIGITAL STEREO OUT DIGITAL STEREO IN AW16G MONITOR OUT 3 Use the [UTILITY] key to access the D.IN • HDD page of the UTILITY screen. 4 Move the cursor to the DIGITAL REC ON/OFF button, and press the [ENTER] key. A message will ask you to confirm your observance of copyright laws. If you accept the conditions described in "Copyright Notice" (→ p. 5), move the cursor to the OK button and press the [ENTER] key. The DIGITAL REC ON/OFF button will be switched ON, and digital audio data input will be enabled. 5 Move the cursor to the DIGITAL PATCH IN field, and turn the [DATA/JOG] dial to select "1/2" (input channels 1/2) as the destination for the input signal from the DIGITAL STEREO IN jack. Note If necessary, use the INIT page of the MONITOR screen to initialize the input channels. 6 Use the Quick Navigation section [RECORD] key to access the DIRECT page of the RECORD screen, and connect input channels 1/2 directly to tracks 1/2. 7 Raise the [STEREO] fader, play back your MD recorder, and check the recording level and monitor level. Note If you want to lower the recording level, access the FADER page of the VIEW screen and lower the on-screen faders for input channels 1/2. (The [GAIN] knobs have no effect on input signals from the DIGITAL STEREO INPUT jack.) 8 When you are finished setting the levels, put the AW16G in record mode, and play back your MD recorder. 170