Yamaha AW16G Owner's Manual - Page 90
Using meters to check the level of each channel, Viewing all parameters for a certain channel
View all Yamaha AW16G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Mixdown and bounce operations Using meters to check the level of each channel During mixdown or bouncing, you can watch meters that indicate the input levels in a single screen. To do so, repeatedly press the Selected Channel section [VIEW] key or hold down the [VIEW] key and use the CURSOR [ ]/[ ] keys to access the METER page of the VIEW screen. In the METER page, the display will change depending on the channel that is currently selected (shown in the upper left of the screen). Press an [INPUT SEL] key to view the meters for the input channels/pad channels, or press a [TRACK SEL] key to view the meters for the track channels. ● If a track channel is selected 21 3 Viewing all parameters for a certain channel Sometimes you will want to see all mix parameters for a certain channel in a single screen. To do this, repeatedly press the Selected Channel section [VIEW] key or hold down the [VIEW] key and use the CURSOR [ ]/[ ] keys to access the CH VIEW page of the VIEW screen. (Some items can also be edited from this page.) The display in the CH VIEW page will change depending on the currently selected channel (shown in the upper left of the screen). Use the [INPUT SEL] keys, pads 1-4, [TRACK SEL] keys, and [STEREO SEL] key to select the channel that you want to view. ● If an input channel, pad channel, or track channel is selected 1 J89 ● If an input channel/pad channel is selected 21 3 23 4 5 6 7 M KL ● If the stereo output channel is selected 1 PEAK button This button switches the level meter peak hold function on/off. When this button is on, a indicator will show the peaks of the level meters, and this indicator will be held. To reset the indicator, temporarily turn off the PEAK button. This setting is shared with the BUS page of the VIEW screen. B PRE/POST buttons These buttons select whether the level meters in the METER page will indicate the pre-fader levels (PRE) or the post-fader levels (POST). This setting is independent from the BUS page of the VIEW screen. C Level meters These indicate the input level of each channel. 2 4 5 67N L 1 Pairing Indicates the pairing status of adjacent odd-numbered/even-numbered channels. Paired channels are indicated by a heart-shaped symbol, and unpaired channels are indicated by a broken heart. Move the cursor here and press the [ENTER] key to switch pairing on/off. Note Pairing cannot be switched off for track channels 9/10- 15/16, pad channels 1-4, and the stereo channel. B ATT knob Move the cursor to this knob and turn the [DATA/ JOG] dial to adjust the attenuation of the signal over a range of 0 to -96 dB before it enters the EQ. This is the same function as the ATT. knob in the EDIT page of the EQ screen. C Phase (except for the stereo output channel) Move the cursor here and press the [ENTER] key to switch the phase of the signal between N (Normal) and R (Reverse). 90