Yamaha AW16G Owner's Manual - Page 95
Eq High Freq, Eq High Gain
View all Yamaha AW16G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
E Parameter page/Return channel page In this area you can edit the various effect parameters. The content and range of the parameters will depend on the currently-used effect type. If the effect is internally connected to the mixer section via send/return, this area will show the mix parameters of the return channel, allowing you to edit them. 3 Move the cursor to the effect parameter that you want to edit, and turn the [DATA/JOG] dial to edit the value. Depending on the effect type, this area may be used to show multiple parameter pages. In this case, repeatedly press the CURSOR [ ] key to access the parameter page that contains the parameter you want to edit. For example, the illustration below shows the parameter pages for the STEREO DELAY effect type. MIX BAL. parameter Tip! The parameter pages show the parameters that are specific to that effect type. However for all effect types, the lower right of the last parameter page will have a MIX BAL. parameter which sets the mix balance between the effect sound and the original sound. 4 To edit the mix parameters of the return channel, access the last parameter page, and then press the CURSOR [ ] key once again. If the effect is internally connected to the mixer section via send/return, you can repeatedly press the CURSOR [ ] key to access the mix parameters of the return channel. The following pages are the same for all effect types. 1 2 3 1 EFF2SEND Adjusts the level at which the signal is sent from the return channel to the other internal effect. Note You cannot send the signal from return channel 1 to insert effect 1 (since this would mean sending the signal back to the same effect itself). For this reason, the EDIT page of the EFF1 screen has no send level to effect 1. For the same reason, the EDIT page of the EFF2 screen has no send level to effect 2. B AUX1SEND C AUX2SEND These adjust the send level of the signal that is sent from the return channel to AUX buses 1/2. D EFF2 PRE/POST Switches the signal that is sent from the return channel to the other effect bus between pre-fader and post-fader. E AUX1 PRE/POST F AUX2 PRE/POST These switch the signals that are sent from the return channel to AUX buses 1/2 between pre-fader and post-fader. 1 2 3 9 4 5 6 1 EQ HIGH GAIN B EQ HIGH FREQ C EQ HIGH Q D EQ H-MID GAIN E EQ H-MID FREQ F EQ H-MID Q These specify the gain, frequency, and Q for the HIGH and HI-MID bands of the return channel EQ. The range of each parameter is the same as in the EDIT page of the EQ screen. 4 5 6 Mixdown and bounce operations 95