Yamaha AW16G Owner's Manual - Page 139
Editing various settings for the song
View all Yamaha AW16G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Editing various settings for the song Here's how to make various settings for a song, such as switching protect on/off and selecting the counter display format and time code format. Note • These settings apply only to the current song. Before you perform this procedure, load the song whose settings you want to edit. • The edited settings will be saved with the song data when you save the song. 1 In the Work Navigate section, press the [SONG] key. The SONG screen will appear. 2 Repeatedly press the [SONG] key or hold down the [SONG] key and use the CURSOR [ ]/[ ] keys to access the SETUP page. 1 32 This page contains the following items. 1 PROTECT button Switches protect on/off. B COUNTER DISPLAY Selects the display format for the counter that appears in the center of the top line in the display. C TIME CODE BASE Selects the format (the number of frames per second) for the time code used by the AW16G. 3 To switch the protect setting on/off, move the cursor to the PROTECT button and press the [ENTER] key. Protect is a setting that prohibits any change to the song data. If protect is turned on, the PROTECT button will be highlighted, and it will not be possible to perform additional recording or editing, or to erase the song. Tip! • We recommend that you turn protect on for important songs. • Even if protect is on, you can still copy the song (→ p. 140) and adjust the mixer settings. 4 To change the counter display format, move the cursor to one of the buttons in the COUNTER DISPLAY area and press the [ENTER] key. In the COUNTER DISPLAY area, use the following buttons to select the display format for the counter that is shown in the center of the top line in the display. ABS (absolute time) ....Display the current location in hours/minutes/seconds/milliseconds, with the absolute time zero location as 0. REL (relative time) ......Display the current location in hours/minutes/seconds/milliseconds, with the relative time zero location as 0. SEC Display the current location in hours/minutes/seconds/milliseconds, with the Start point as 0. T.C Display the current location in time code (hours/minutes/seconds/ frames), with the Start point as 0. REMAIN When this button is on, the remaining recordable time with the selected number of recording tracks will be displayed instead of the current location. Note • The counter in the upper right of the display always shows the current location in measure/beat units, relative to the Start point. • The measure/beat display will depend on the settings in the TEMPO page of the SONG screen. For details, refer to "Creating a tempo map" (→ p. 142). 5 To change the time code frame rate, move the cursor to one of the buttons in the TIME CODE BASE area, and press the [ENTER] key. In the TIME CODE BASE area you can choose one of the following frame rates to specify the minimum unit of time code. 24 24 frames/second 25 25 frames/second 30 30 frames/second (30 non-drop frame) 30D 29.97 frames/second (30 dropframe) 13 Song management Tip! This setting affects both the counter time code display and the MTC that the AW16G transmits and receives. If the AW16G is sending or receiving MTC to or from an external device, you must set both devices to the same frame rate. Note With the exception of COUNTER DISPLAY, the settings in the SETUP page of the SONG screen cannot be changed while the AW16G is running. 139