Biostar VP5200SS16 Administrator Guide - Page 174

5. Customize Settings - Time: Manually set the device time. - Sync with Host PC Time: Check this box to get the time of the lcoal PC which BioStar client program is installed on. The time will be displayed in the Date and Time spin boxes right below this option and you can set the device's time to match this time by clicking Set Time. - Get Time: Get the current time displayed by the device. - Set Time: Set the time on the device.  Sensor Mode - Always On: Set the device sensor to be always available on standby (Always or Disable). - ID Entered: Set the device sensor to be available on standby only after a valid ID is entered (Always or Disable). - OK Pressed: Set the device sensor to be available on standby only after the OK key is pressed (Always or Disable).  Operation Mode: For each of the following options, click the corresponding checkbox to enable Double Verification Mode, which requires verification of two users' credentials to gain entry to a door. - Fingerprint Only: Set the device to require fingerprint only authorization (Always, Disable, or Custom Schedule). - Password Only: Set the device to require password only authorization (Always, Disable, or Custom Schedule). - Fingerprint/Password: Set the device to require fingerprint or password authorization (Always, Disable, or Custom Schedule). - Fingerprint+Password: Set the device to require fingerprint plus password authorization (Always, Disable, or Custom Schedule). - Card Only: Set the device to require only card authorization (Always, Disable, or Custom Schedule). - Private Auth: Set the device to allow a private authorization method (Disable or Enable). If enabled, the authentication mode of the user will be determined by a user's "Authorization" setting, which is located on the Details tab. If disabled, the authentication mode will be determined by operation mode settings of the device.  Mifare - Not use Mifare: Check this box to disable MIFARE card authorization. - Use Template on Card: Check this box to use the template on the MIFARE card for authorization. - View Mifare Layout: Click this button to configure the MIFARE layout used by the device. For more information about configuring MIFARE layouts, please see section 3.6.4.7.  Card ID Format - Format Type: Set the type of pre-processing to occur on card ID data (Normal or Wiegand). If "Normal" is selected, the card ID data will be 174 Copyright ©2014, Suprema Inc. On the web: www.supremainc.com