Biostar VP5200SS16 Administrator Guide - Page 270

5. Customize Settings  Delay (sec) - Arm: Set the length of time (in seconds) to delay before arming the zone. - Disarm: Set the length of time (in seconds) to delay before disarming the zone.  Arm/Disarm Type: Specify settings for arming or disarming zones. For more information for configuring arm and disarm settings, see 3.5.2.5. For more information on setting up alarms, see section 3.10.  External Input/Out: Specify settings for enabling the BioStar system to antomatically arming or disarming zones. For more information on configuring external input/output settings, see 3.5.2.6. For more information on setting up alarms, see section 3.10. 5.3.3.2 Alarm tab The Alarm tab allows you to specify alarm actions and an output device for an alarm zone.  Action - Program Sound: Activate and select a sound from the drop-down list to be emitted by the BioStar program. Then, specify the duration ("play count") of the sound in seconds. If you set the Play Count to 0, the specified sound will play until someone with administrative privileges manually stops the sound via the Realtime Monitoring tab in the Monitoring pane. To add custom sounds to the list, see section 3.10.1.2. - Device Sound: Activate and select a sound to be emitted by devices connected to the door. - Send Email: Activate and setup emails to be sent by the system. For more information about sending alert emails, see section 3.10.2. - Output Device: Activate and select a device to output an alarm signal. - Output Port: Select an output port to use when sending the alarm signal. - Output Signal: Select an output signal to send. 270 Copyright ©2014, Suprema Inc. On the web: www.supremainc.com