Biostar VP5200SS16 Administrator Guide - Page 83

3. Setup the BioStar System EM4100 and HID cards require only a card ID to complete card registration, while MIFARE and iCLASS cards support two operation modes: Card Serial Number (CSN) and Templateon-Card modes. FeliCa cards support only the CSN mode. When using the CSN mode, you can read the serial number just as you would for an EM4100 or HID card. When using Template-on-Card mode, you must record the user information, including fingerprint templates, directly to the card. Follow the procedures below to issue the appropriate type of card and then add it to the user's account. 3.6.4.1 Issue EM4100 cards To register a EM4100 card for a user: 1. Click User in the shortcut pane. 2. In the navigation pane, click a user's name. 3. In the User pane, click the Card tab. 4. Select a "EM4100" from the Card Type drop-down list. 5. Click Card Management. This will open the Card Management dialog box. 6. Select a Device ID from the drop-down list. 7. Enter a card ID (32 bits) and custom ID (8 bits) either manually or by reading from the card (you can also click Use User ID to insert the user's ID in these fields):  To enter the data manually, type the card ID and custom ID in the corresponding fields, click OK, and then skip to step 8.  To read the data from the card, click Read Card (the LED on the device you selected will begin flashing) and then place the card on the device. After the card has been read, click OK. 8. Click Apply to save the card to the user's account. 3.6.4.2 Issue HID proximity cards To register a HID proximity card for a user: 1. Click User in the shortcut pane. 2. In the navigation pane, click a user's name. 83 Copyright ©2014, Suprema Inc. On the web: www.supremainc.com