Cisco IE-3000-8TC Administration Guide - Page 285
PRI-Specific Settings, If you check the Transmit UTF-8 for Calling Party Name check
![]() |
View all Cisco IE-3000-8TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
Connection Settings Setting Channel Selection Order Channel IE Type Description Select the order in which channels or ports are enabled from first (lowest number port) to last (highest number port), or from last to first. Valid entries include TOP DOWN (first to last) or BOTTOM UP (last to first). If you are not sure which port order to use, select TOP DOWN. Select one of the following values to specify whether channel selection is presented as a channel map or a slot map: • Timeslot Number-B-channel usage always indicates actual time slot map format (such as 1-15 and 17-31 for E1). • Slotmap-B-channel usage always indicates a slot map format. • Use Number When 1B-Channel usage indicates a channel map for one B-channel but indicates a slot map if more than one B-channel exists. • Continuous Number-Configures a continuous range of slot numbers (1-30) as the E1 logical channel number instead of the noncontinuous actual time slot number (1-15 and 17-31). Delay for first restart (ticks) Enter the rate at which the spans are brought in service. The delay occurs when many PRI spans are enabled on a system and the Inhibit Restarts at PRI Initialization check box is unchecked. For example, set the first five cards to 0 and set the next five cards to 16. (Wait 2 seconds before bringing them in service.) Delay between restarts (ticks) Enter the time between restarts. The delay occurs when a PRI RESTART is sent if the Inhibit Restarts check box is unchecked. Inhibit Restarts at PRI Initialization A RESTART or SERVICE message confirms the status of the ports on a PRI span. If RESTART or SERVICE messages are not sent, Cisco Business Edition 3000 assumes the ports are in service. When the D-Channel successfully connects with another PRI D-Channel, it sends a RESTART or SERVICE message when this check box is unchecked. Enable G. Clear Check this check box to enable G. Clear Codec support. Checking this check box causes echo cancellation and zero suppression for outbound calls to be disabled. Trasmit UTF-8 for Calling Party Name If you check the Transmit UTF-8 for Calling Party Name check box, the gateway sends unicode for the calling party name. PRI-Specific Settings OL-27022-01 Administration Guide for Cisco Business Edition 3000, Release 8.6(4) 265
![](/manual_guide/products/cisco-ie30008tc-administration-guide-dff24ae/285.png)