Cisco IE-3000-8TC Administration Guide - Page 326
Group A Caller ID End, Debounce Timer ms
![]() |
View all Cisco IE-3000-8TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 326 highlights
Connection Settings Setting Answer Signal Billing Category Category Debounce Timer (ms) DNIS Complete Group A Caller ID End Description By default, the gateway sends Backward Group-A-3 (address complete, change over to Group-B) after DNIS/ANI collection. When a switch sends the Group-II category, the gateway sends a Group-B answer signal and connects. If Group-A answer signal (A-6) is configured, the gateway does not send A-3 after address collection. It sends A-6 and connects. The default value is B1 for the Brazil or Mexico country pack and B6 for the Saudi Arabia country pack. Specify the billing category that the gateway sends when it receives A6. The default value is 2. (Only for the Mexico country pack) Specifies the type of call (subscriber with priority or normal subscriber). ITU default is 1 (normal subscriber). For outgoing calls, the gateway sends this category. If the category is not configured, the gateway sends the country default category. For incoming calls, the gateway collects the category from the switch. No special handling is based on the category. The default value is 2. Any line signaling change is considered valid only if it lasts at least the length of this timer. The default is 40 ms for all countries. Tune this based on the interface. Sends Forward Group-I-15 signal after dialing out all the DNIS digits. Effective for outgoing calls only. Configure this if the switch requires it, or if it improves call setup time by 3 seconds. The default value is True Countries such as China, Thailand, and Mexico use Group-C signals for ANI collection. If this is configured, the gateway uses the Backward Group-A-1 signal as Caller ID End. If it is not configured, the gateway uses the country default, which might be a Group-C signal. The default value is Disable for the Brazil or Saudi Arabia country pack. The default value is Enable for the Mexico country pack. Administration Guide for Cisco Business Edition 3000, Release 8.6(4) 306 OL-27022-01
![](/manual_guide/products/cisco-ie30008tc-administration-guide-dff24ae/326.png)