Cisco IE-3000-8TC Administration Guide - Page 43
PSTN Connection Settings
![]() |
View all Cisco IE-3000-8TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Components of the Cisco Business Edition 3000 System with a particular station within the system. In the case of the All Call Types option, customers are responsible for determining how calls on a trunk are routed (for example: attendant number or directory number). In the case of Emergency Calls Only, a call-back pattern is set up that ensures that incoming calls are routed to the last number that called out on that particular gateway. If an ELIN is associated with an analog trunk, Cisco recommends that it be configured on that analog trunk. If the ELIN is using a digital gateway (example: T1 or PRI connection), Cisco recommends that it be configured on the site. To confirm that the configuration for emergency calling is successful, after the SPA8800 is configured, go to the site page and confirm that the DID for that trunk is listed as an ELIN. If it is not listed as an ELIN, check the other sites to see if it appears on one of them, it may have been set up on the wrong site. If this happens, check the IP address and subnet settings in Cisco Business Edition 3000 to ensure that the gateway is registering at the correct site. Note The manner in which a particular SPA8800 is associated with a site is based on the IP address and the subnets that have been set up for that site. PSTN Connection Settings For information about how to edit the SPA8800 connections, see Connection Type: FXO, on page 294. Perform the Initial Setup on the SPA8800 for IP Addresses using SPA Interactive Voice Response The SPA8800 requires setup through the SPA Interactive Voice Response (IVR) menu to locate the Cisco Business Edition 3000. Use the following procedure to perform this setup. Procedure Step 1 Step 2 Step 3 Step 4 Step 5 Connect an analog phone to port 1. Go off hook and enter the configuration menu by pressing the * (star) key four times. Enter 101 followed by the # (pound) key to set the Internet connection type, followed by 1# to set it to static IP addressing. Enter 111# to set the static IP address. Note DHCP must be set to Disabled; otherwise you hear Invalid option if you try to set this value. A password is required. Enter IP address using numbers on the telephone key pad. Use the * (star) key to enter a decimal point, followed by the # (pound) key. Press 1 to save the configuration change. If, while entering a value (for example, an IP address), you decide to exit without saving any changes, you must press the * (star) key twice within a half-second window of time. Otherwise, the entry of the * (star) key will be treated as a dot (decimal point). Tip To enter IP address, use numbers 0 - 9 on the telephone key pad and use the * (star) key to enter a decimal point. OL-27022-01 Administration Guide for Cisco Business Edition 3000, Release 8.6(4) 23
![](/manual_guide/products/cisco-ie30008tc-administration-guide-dff24ae/43.png)