Cisco SA520-K9 Administration Guide - Page 143

Configuring VPN Configuring an IPsec VPN Tunnel for Remote Access with a VPN Client 7 - Cisco QuickVPN X-Auth is an IPsec standard that extends the authentication in native IPsec to provide user credentials. XAUTH can be used when additional client security is required with IPsec clients such as Greenbow. QuickVPN is a propriety Cisco/Linksys client which uses user authentication but the implementation is specific only to Quick VPN. This option should be selected when the clients use QuickVPN Client. • Allow user to change password?: If you chose Cisco QuickVPN for the Remote Peer Type, you can check this box to allow the user to change the password. • Password: Enter an alphanumeric password for this user. • Confirm Password: Re-enter the characters that you entered in the Password field. • LAN IP address: Enter the LAN IP subnet to which the remote user will have access. The subnet should be part of the LAN or VLAN IP addresses. • Subnet Mask: Enter the subnet mask for the local subnet. STEP 4 Click Apply to save your settings. STEP 5 Repeat as needed for each user that you need to add. NOTE Next steps: • If you are using the Getting Started (Advanced) page, click Getting Started > Advanced to return to the list of configuration tasks for IPsec VPN Remote Access. • Optionally, review and modify the default settings and policies. See Advanced Configuration of IPsec VPN, page 144. • For Cisco QuickVPN, you also must enable Remote Management. See RMON (Remote Management), page 197. Cisco SA500 Series Security Appliances Administration Guide 143