D-Link DGS-3200-10 Product Manual - Page 185

xStack® DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch JWAC Port Settings Users can configure JWAC port settings for the Switch. To view the following window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Port Settings: Figure 5 - 52. JWAC Port Settings window To set the JWAC on individual ports for the Switch, complete the following fields: Parameter Description From Port To Port Aging Time (1-1440) Use this drop-down menu to select the beginning port of a range of ports to be enabled as JWAC ports. Use this drop-down menu to select the ending port of a range of ports to be enabled as JWAC ports. This parameter specifies the time period during which an authenticated host will remain in the authenticated state. Enter a value between 0 and 1440 minutes or tick the Infinite check box. The default value is 1440. A value of 0 indicates the authenticated host will never age out on the port. MAC Authenticating This parameter specifies the maximum number of host process authentication attempts Host (1-10) allowed on each port at the same time. The default value is 10. Enter a value between 1 and 10 attempts. Idle Time (1-1440) Block Time (0-300) Mode State If there is no traffic during the Idle Time parameter, the host will be moved back to the unauthenticated state. The default value is infinite. To change this value, first untick the Infinite check box and then enter a value between 0 and 1440 minutes. A value of 0 indicates the Idle state of the authenticated host on the port will never be checked. This parameter is the period of time a host will be blocked if it fails to pass authentication. Enter a value between 0 and 300 seconds. The default value is 0. Toggle between Host Based and Port Based. Use this drop-down menu to enable the configured ports as JWAC ports. Click Apply to implement changes made. 172