D-Link DGS-3200-10 Product Manual - Page 219

xStack® DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch To set the Access Rule for Ethernet, adjust the following parameters and click Apply. Parameter Description Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100. Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access rule are not forwarded by the Switch and will be filtered. Ethernet Type (0- Enter the appropriate Ethernet Type information. FFFF) Time Range Name Tick the check box and enter the name of the Time Range settings that has been previously configured in the Time Range Settings window. This will set specific times when this access rule will be implemented on the Switch. Ports Ticking the All Ports check box will denote all ports on the Switch. To view the settings of a previously correctly configured rule, click the co rresponding Show Details button on th e CPU Access Rule List window to view the following window: Figure 6 - 34. CPU Access Rule Detail Information window for Ethernet To establish the rule for a previously created CPU Access Profile: To configure the Access Rules for IP, open the CPU Access Profile List window and click Add/View Rules for an IP entry. This will open the following window. Figure 6 - 35. CPU Access Rule List window for IPv4 To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule button: 206