D-Link DGS-3200-10 Product Manual - Page 221

xStack® DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch To establish the rule for a previously created CPU Access Profile: To configure the Access Rules for IP, ope n the CPU Access Profile List window and click Add/View Rules for an IPv6 entry. This will open the following window. Figure 6 - 38. CPU Access Rule List window for IPv6 To remove a previously created rule, click the corresponding Delete Rules button. To add a new Access Rule, click the Add Rule button: Figure 6 - 39. Add Access Rule window for IPv6 To set the Access Rule for IPv6, adjust the following parameters and click Apply. Parameter Description Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100. Action Select Permit to specify that the packets that match the access rule are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access rule are not forwarded by the Switch and will be filtered. Flow Label Configuring this field, in hex form, will instruct the Switch to examine the flow label field of the IPv6 header. This flow label field is used by a source to label sequences of packets such as nondefault quality of service or real time service packets. Time Range Name Tick the check box and enter the name of the Time Range settings that has been previously configured in the Time Range Settings window. This will set specific times when this access rule will be implemented on the Switch. 208