Dell PowerConnect W Clearpass 100 Software 3.7 Deployment Guide - Page 291

Secondary network interfaces have the same name as the underlying physical interface, with a suffix such as ":1", ":2" and so on for each subsequent IP address created. All secondary interfaces will be brought down if the corresponding physical interface is brought down. Login Access Control Both guests and operators may use HTTP or HTTPS to access the Amigopod user interface. The system does not distinguish between these types of users at the protocol level. Authentication and role based access control is used to identify operators and their level of access to the system. For security reasons, it may be desirable to prevent guests from obtaining login access to the administrator user interface. This may be achieved by first ensuring that guests and operators are using different network address ranges, and then defining those networks in the Network Login Access form. To access this form, navigate to Administrator > Network Setup then click the Network Login Access command link. The login access rules that have been defined will only apply to the components of the system that require an operator login. Guest specific pages that do not require an operator login are not affected by any allow/ deny rules and are always available, regardless of the IP address used to access them. The Network Login Access form also controls the access restrictions used for SSH console access, if it is enabled. See "Changing Network Security Settings" in this chapter for more information about remote console access via SSH. The 'Allowed Access' and 'Denied Access' fields are access control lists that determine if an operator is permitted to view the login page. You can specify multiple IP addresses and networks, one per line, using the following syntax:  1.2.3.4 - IP address  1.2.3.4/24 - IP address with network prefix length  1.2.3.4/255.255.255.0 - IP address with explicit network mask Amigopod 3.7 | Deployment Guide Administrator Tasks | 291