Cisco WS-C3560E-48PD-SF Command Reference - Page 132

dot1x port-control Chapter 2 Catalyst 3560 Switch Cisco IOS Commands • EtherChannel port-Do not configure a port that is an active or a not-yet-active member of an EtherChannel as an IEEE 802.1x port. If you try to enable IEEE 802.1x on an EtherChannel port, an error message appears, and IEEE 802.1x is not enabled. Note In software releases earlier than Cisco IOS Release 12.2(20)SE, if IEEE 802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join the EtherChannel. • Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) destination ports-You can enable IEEE 802.1x on a port that is a SPAN or RSPAN destination port. However, IEEE 802.1x is disabled until the port is removed as a SPAN or RSPAN destination. You can enable IEEE 802.1x on a SPAN or RSPAN source port. To globally disable IEEE 802.1x on the switch, use the no dot1x system-auth-control global configuration command. To disable IEEE 802.1x on a specific port, use the no dot1x port-control interface configuration command. Examples This example shows how to enable IEEE 802.1x on a port: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# dot1x port-control auto You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC command. Related Commands Command show dot1x [interface interface-id] Description Displays IEEE 802.1x status for the specified port. 2-100 Catalyst 3560 Switch Command Reference 78-16405-05