Cisco WS-C3560E-48PD-SF Command Reference - Page 150

interface range Chapter 2 Catalyst 3560 Switch Cisco IOS Commands interface range Use the interface range global configuration command to enter interface range configuration mode and to execute a command on multiple ports at the same time. Use the no form of this command to remove an interface range. interface range {port-range | macro name} no interface range {port-range | macro name} Syntax Description port-range macro name Port range. For a list of valid values for port-range, see the "Usage Guidelines" section. Specify the name of a macro. Defaults This command has no default setting. Command Modes Global configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines When you enter interface range configuration mode, all interface parameters you enter are attributed to all interfaces within the range. For VLANs, you can use the interface range command only on existing VLAN switch virtual interfaces (SVIs). To display VLAN SVIs, enter the show running-config privileged EXEC command. VLANs not displayed cannot be used in the interface range command. The commands entered under interface range command are applied to all existing VLAN SVIs in the range. All configuration changes made to an interface range are saved to NVRAM, but the interface range itself is not saved to NVRAM. You can enter the interface range in two ways: • Specifying up to five interface ranges • Specifying a previously defined interface-range macro All interfaces in a range must be the same type; that is, all Fast Ethernet ports, all Gigabit Ethernet ports, all EtherChannel ports, or all VLANs. However, you can define up to five interface ranges with a single command, with each range separated by a comma. Valid values for port-range type and interface: • vlan vlan-ID - vlan-ID, where VLAN ID is from 1 to 4094 • fastethernet module/{first port} - {last port}, where module is always 0 2-118 Catalyst 3560 Switch Command Reference 78-16405-05