Cisco WS-C3560E-48PD-SF Command Reference - Page 407

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands show controllers power inline show controllers power inline Use the show controllers power inline user EXEC command to display the values in the registers of the specified Power over Ethernet (PoE) controller. show controllers power inline [instance] [ | {begin | exclude | include} expression] Syntax Description instance | begin | exclude | include expression (Optional) Power controller instance, where each instance corresponds to four ports. See the "Usage Guidelines" section for more information. If no instance is specified, information for all instances appear. (Optional) Display begins with the line that matches the expression. (Optional) Display excludes lines that match the expression. (Optional) Display includes lines that match the specified expression. Expression in the output to use as a reference point. Command Modes User EXEC Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines For the Catalyst 3560-48PS switches, the instance range is 0 to 11. For the Catalyst 3560-24PS switches, the instance range is 0 to 5. For the Catalyst 3560G-48PS switches, the instance range is 0 to 2. For instances other than 0 to 2, the switches provides no output. For the Catalyst 3560G-24PS switches, the instance range is 0 to 1. For instances other than 0 to 1, the switches provides no output. Though visible on all switches, this command is valid only for PoE switches. It provides no information for switches that do not support PoE. The output provides information that might be useful for Cisco technical support representatives troubleshooting the switch. Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output do not appear, but the lines that contain Output appear. 78-16405-05 Catalyst 3560 Switch Command Reference 2-375