Cisco WS-C3560E-48PD-SF Command Reference - Page 31

Chapter 1 Using the Command-Line Interface CLI Command Modes VLAN Configuration Mode You can use the VLAN configuration commands to create or modify VLAN parameters for VLAN IDs 1 to 1005. Enter the vlan database privileged EXEC command to access VLAN configuration mode: Switch# vlan database Switch(vlan)# The supported commands can vary depending on the version of software in use. To display a comprehensive list of commands, enter a question mark (?) at the prompt. Switch(vlan)# ? To return to privileged EXEC mode, enter the abort VLAN configuration command to abandon the proposed database. Otherwise, enter exit to implement the proposed new VLAN database and to return to privileged EXEC mode. When you enter exit or apply, the configuration is saved in the VLAN database; configuration from VLAN configuration mode cannot be saved in the switch configuration file. Line Configuration Mode Line configuration commands modify the operation of a terminal line. Line configuration commands always follow a line command, which defines a line number. Use these commands to change terminal parameter settings line-by-line or for a range of lines. Use the line vty line_number [ending_line_number] command to enter line configuration mode. The new prompt means line configuration mode. The following example shows how to enter line configuration mode for virtual terminal line 7: Switch(config)# line vty 0 7 The supported commands can vary depending on the version of software in use. To display a comprehensive list of commands, enter a question mark (?) at the prompt. Switch(config-line)# ? To exit line configuration mode and to return to global configuration mode, use the exit command. To exit line configuration mode and to return to privileged EXEC mode, enter the end command, or press Ctrl-Z. 78-16405-05 Catalyst 3560 Switch Command Reference 1-5