Cisco WS-C3560E-48PD-SF Command Reference - Page 89

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands cluster enable cluster enable Use the cluster enable global configuration command on a command-capable switch to enable it as the cluster command switch, assign a cluster name, and to optionally assign a member number to it. Use the no form of the command to remove all members and to make the cluster command switch a candidate switch. cluster enable name [command-switch-member-number] no cluster enable Syntax Description name command-switch-member-number Name of the cluster up to 31 characters. Valid characters include only alphanumerics, dashes, and underscores. (Optional) Assign a member number to the cluster command switch of the cluster. The range is 0 to 15. Defaults The switch is not a cluster command switch. No cluster name is defined. The member number is 0 when the switch is the cluster command switch. Command Modes Global configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines Enter this command on any command-capable switch that is not part of any cluster. This command fails if a device is already configured as a member of the cluster. You must name the cluster when you enable the cluster command switch. If the switch is already configured as the cluster command switch, this command changes the cluster name if it is different from the previous cluster name. Examples This example shows how to enable the cluster command switch, name the cluster, and set the cluster command switch member number to 4. Switch(config)# cluster enable Engineering-IDF4 4 You can verify your setting by entering the show cluster privileged EXEC command on the cluster command switch. 78-16405-05 Catalyst 3560 Switch Command Reference 2-57