Cisco WS-C3560E-48PD-SF Command Reference - Page 67

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands class Examples This example shows how to create a policy map called policy1. When attached to the ingress direction, it matches all the incoming traffic defined in class1, sets the IP Differentiated Services Code Point (DSCP) to 10, and polices the traffic at an average rate of 1 Mbps and bursts at 20 KB. Traffic exceeding the profile is marked down to a DSCP value gotten from the policed-DSCP map and then sent. Switch(config)# policy-map policy1 Switch(config-pmap)# class class1 Switch(config-pmap-c)# set dscp 10 Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit Switch(config-pmap-c)# exit You can verify your settings by entering the show policy-map privileged EXEC command. Related Commands Command class-map police policy-map set show policy-map trust Description Creates a class map to be used for matching packets to the class whose name you specify. Defines a policer for classified traffic. Creates or modifies a policy map that can be attached to multiple ports to specify a service policy. Classifies IP traffic by setting a DSCP or IP-precedence value in the packet. Displays quality of service (QoS) policy maps. Defines a trust state for the traffic classified through the class policy-map configuration command or the class-map global configuration command. 78-16405-05 Catalyst 3560 Switch Command Reference 2-35