Cisco WS-C3560E-48PD-SF Command Reference - Page 212

ipv6 access-list Chapter 2 Catalyst 3560 Switch Cisco IOS Commands ipv6 access-list Use the ipv6 access-list global configuration command to define an IPv6 access list and to place the switch in IPv6 access list configuration mode. To remove the access list, use the no form of this command. ipv6 access-list access-list-name no ipv6 access-list access-list-name Note This command is available only if the switch is running the advanced IP services image and you have configured a dual IPv4 and IPv6 Switch Database Management (SDM) template on the switch. Syntax Description access-list-name Name of the IPv6 access list. Names cannot contain a space or quotation mark or begin with a numeric. Defaults No IPv6 access list is defined. Command Modes Global configuration Command History Release 12.2(25)SED Modification This command was introduced. Usage Guidelines To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan) global configuration command and reload the switch. The ipv6 access-list command is similar to the ip access-list command, except that it is IPv6-specific. Note IPv6 ACLs are defined by a unique name (IPv6 does not support numbered ACLs). An IPv4 ACL and an IPv6 ACL cannot share the same name. See the ipv6 access-list and permit (IPv6 access-list configuration) commands for more information on filtering IPv6 traffic based on IPv6 option headers and optional, upper-layer protocol-type information. See the "Examples" section for an example of a translated IPv6 ACL configuration. 2-180 Catalyst 3560 Switch Command Reference 78-16405-05